One -sided bird feeder.
Stores of this type prefer nuts, tits, cuts and finch. The feeder can be installed on a pillar or on a tree or specially hanged on a wire so that it is unstable and does not attract birds, which are usually considered annoying (sparrows and blue pricks).
In addition to the fact that this feeder protects bird food from the wind and rain, it is also equipped with a bunker, in which a lot of food is placed. Therefore, you can fill the feeder not so often, but it is easy to clean it. The width of the gap in the bunker can be adjusted, which allows you to change the feed rate. However, if the width of the gap is more than half of the inch (13 mm), the bird will be able to stick the head into it and get stuck in the feeder.
Lumber
• Cedar board 4 feet long and with a cross section of 1 x 8 inch
Furniture
• 2 brackets in size 12 inches, otherwise the bird will be able to put his head into the gap and get stuck. In place, adjust the height of the brackets. Attach to the bottom of the side (d) and (d). Install the roof (e) on top and mount the loop. Open the roof and insert the acrylic plate into the grooves of the side walls so that its lower edge rests against the brackets.
Installation of the feeder.
Pour the food. Using screws, attach the feeder to the selected support.